Dragonfly Barrettes

Free-Macrame-Patterns.com Left Side Background Image

Dragonfly Barrettes



Description: Dragonfly Barrettes are really pretty if you make them with ribbon or lace. They would make a perfect gift for someone who likes dragonflies. You could also use this simple design as part of a bracelet or belt. Try using this design to make a bookmark or as decoration for a gift. This pattern might be a bit challenging for younger children. Supplies Needed: Cord: 2mm – 4mm Macramé Cord or similar material. (2) Beads (optional) 1 pair of Barrettes Knots Used: Overhand Knot, single & chain Step 1: Cut two cords at least 60 inches long, one for each barrette.

		Step 2: Fold the cord in half and tape it to the table. Using the left end, make an Overhand Knot. You should tie it in a counter-clockwise circle as you bring the end around and through the loop. Don’t tighten it yet.

		Step 3: Now take the right strand and make another Overhand Knot, this time, in a clockwise direction. Pass the end through the loop of the first knot. You’ll come into it from below. This will link the two together.

		Step 4: Tightening it is the tricky part. Take a good look at the two knots you just made. The Overhand knot is a circle, with both an inner and outer part. Locate the inner section, where the two knots connect. Pull this part through the outer section of the knot, on both sides. This will make the wings of the Dragonfly. As you pull, the knot will tighten. Adjust the loops so they are both the same size. Be sure to leave the small loop up top for the head.

Step 5: Using the two dangling ends, make a second set of wings the same way. Then tie a third pair just below the second ones. Step 6: Lay the first part of the dragonfly on the barrette. Tie an Overhand knot with both ends, making sure they go around it. Note: In the photos, I made the dragonfly to be used as a bookmark, so did not attach the barrette. Step 7: Then make a chain of Overhand knots, so they end up right next to each other. These don’t need to go around the barrette. Add a bead after 3 are tied. Then make 3 more. Step 8: To finish, attach another bead, and tie a tight Overhand Knot just below it. If you can, feed the ends back through it. If not, just cut the leftover cord close to the knot. Apply glue so it won’t come out. Step 9: Make a second Dragonfly Barrette the same way.

These Dragonfly Barrettes can be made to order. If you would like to buy a pair, or just have questions, please Contact Me. Specify which item you are interested in.

Back to Macrame for Kids

Free-Macrame-Patterns.com Footer